1 ads Wood & Metal Lathes & Lathe Tools for Sale in Ipswich, Suffolk

A handy small scribing block which is really useful when setting work in a 4 jaw chuck of a lathe. Also gas fine adjustment.

Surplus to requirements as no longer have a wood lathe. Collection from NR7 or I can post it

Pratt Burnerd Ltd 10inch 4 jaw lathe chuck. GZ4426 in excellent condition. Viewing welcome in Gillingham Kent

Face plate 12 inch for a lathe. In good condition. Viewing welcome in Gillingham Kent.

Multispeed Woodturning lathe with 4 jaw chuck and tools, all good working order. Come take a look. Sold on behalf of Men's Shed, all money goes towards them. Thanks. Offers welcome !!!what you see on the black base is not to be sold with the lathe

Vintage cast iron lathe, coronet. Good little benchtop machine, working condition. Sold on behalf of Men's Shed, all proceeds go to them. Collection of Men's Shed Norwich thanks!

6-Speed 240V wood turning lathe. Spindle height above the base is approx. 125mm. Distance between centres approx. 360mm. Collection only

A nice little pair of vee blocks complete with clamp, ideal for use with a lathe or milling machine. Just need a clean up.

A Pair of Left and Right hand turning tool holders in good used condition and complete with additional 1/4 inch square toolbits.

A Pair of Left and Right HSS Turning tool holders in good used condition and complete with a new piece of tool steel for each holder.

A right hand turning tool holder for high speed steel toolbits. This in good used condition and is supplied with an unused piece of 1/4 inch square tool steel.

Fully working wood lathe, comes with spare parts as shown. Bought it a few years ago but haven't had a chance to get into using it so it's time to move it on. Collection Cambridge CB4

still available. no offers. did works but recently plugged it in and didn't go. red button missing off switch but does work. as per pictures.

This drill chuck is on a 2 morse taper and comes with a 1 and a 2 Morse taper interchangeable collects. There's also a 2-3 Morse taper sleeve.

An older Burnerd 3 jaw chuck just with inside jaws but still in decent used condition. Comes with an unused Myford backplate to suit ML7, ML7R, SUPER 7, and ML10 lathes. There is a fault on no.3 jaw. The backplate will require turning and drilling

Here's my 10 Irwin Marple chisel set no longer needed

A nice knurling tool with fine,medium,and coarse knurls. Would be ideal on a Colchester or a Harrison lathe.

A larger straight knurling tool for use on a Colchester lathe or similar. Has three sets of knurls.

Three smaller size knurling tools for use on a Myford, Boxford or similar size lathe. In decent used condition.

I have 14 piece Kennedy combination spanner set in excellent used condition. The plastic tool roll is a bit scruffy.

A set of four Myford lathe faceplate clamps in good used condition. Can also be used on the vertical slide or a milling machine.

Old lathe unearthed from a mate's workshop.

This is a small keyless chuck with a capacity of 5.5mm. It has a 1 morse taper and with the 1-2 Morse taper sleeve will fit aMyford lathe or similar. In good used condition.

This magnetic base for holding DTI 's etc, it is excellent used condition and still in its original box.